2003 Ford Focus Stalls While Driving. It sounds like the fuel supply is being interrupted. 11/03/2004 while driving, the engine stalled intermittently.
2003 Ford Focus SE 1/4 mile trap speeds 060 from dragtimes.com
Allow it to dry completely before reinstalling the sensor into. The contact stated that while driving at various speeds, the vehicle suddenly stalled. Web 1 report 4 le levy from united states 8 years ago you should first check both the battery and alternator.
Web Motor Vehicle Maintenance & Repair:
11/03/2004 while driving, the engine stalled intermittently. Average repair cost is $620 at 98,000 miles. The contact stated that while driving at various speeds, the vehicle suddenly stalled.
Car Shuts Down While Driving.
Occasionally will have to be stopped. Web news ford recalling nearly 1.5 million focus cars over stalling issue focus cars from the past seven model years may stall unexpectedly because of a gas. The consumer managed to restart the vehicle.
Web Jacobandnickolas Expert Hi, The Idea That It Reacts Differently At Different Times Leads Me To Believe It Is Something With A Module Or A Bad Connection.
Web worst 2003 ford focus problems #1: Web if your ford focus’s engine timing is off, it’s going to stall out, misfire, and altogether not run properly. Web 1 report 4 le levy from united states 8 years ago you should first check both the battery and alternator.
Web The 2003 Ford Focus Has 10 Problems Reported For Engine Stalls/Dies While Driving.
Web discussion starter · jun 19, 2005 my 2003 ford focus has recently been stalling and downshifting on the highway when i hit a bump, occasionally it would die or. Loses all power, lights, etc. My 2003 ford focus has a problem where the engine shudders and shuts off when while driving, especially when pressing.
This Usually Means That Either The Filter Is Blocked, One Of The Lines Is Blocked, Or The Breather Is Blocked, Or As.
It sounds like the fuel supply is being interrupted. Web spray the exposed sensor wires and sensor disc on the end of the sensor that fits inside the housing, using maf cleaner. Allow it to dry completely before reinstalling the sensor into.
